![]() ![]() It is hand-assembled with silicone gaskets and stainless-steel fasteners, and pressure tested. The Distribution Plate is machined on a CNC router built from thick sheets of cast acrylic. Due to this, we selected the most high-end materials manufacturing process. There is no hidden or backside, and this also goes for the components being installed. With the level of transparency and being an open case, we wanted it to be a celebration of the raw materials. The two on top of the PSU shroud cannot be used with vertically mounted GPUs.Įvery component of Spectre is CNC machined from a solid block of material. Two are on the top of the PSU shroud and there are four inside of the PSU shroud. Spectre 3.0 has 6x 2.5” Drive positions, 4 of these can be used at the same time. The two on top of the PSU shroud cannot be used with vertically mounted GPUs. For the cooling system, it can fit 2x 360mm radiators 60mm thick with a single set of fans and a powerful D5 pump. It is designed to fit the RTX 3090 Founders Edition even with the stock cooler. Spectre 3.0 fits XL-ATX motherboards and has 8 expansion slots. They can be clipped in very quickly and there is far less work to do for clean cable management. The cable channels and combs are designed for 4mm sleeved cables. The fill port is at the highest point on the back of the case and the drain point at the lowest point. The reservoir was designed to remove air as quickly as possible making the loop easier to fill. The pump top was designed for the D5 pump, maximizing flow to and from the distribution plate. This meant that we could focus more on optimization than would normally be possible. With the integration we did not just develop a case, we also had to develop all the integrated components. For Spectre's integration, the position of each integrated port and cable routing hole was carefully chosen based on statistics and our experience Theoretically the more integration the less compatibility. The pump and reservoir combo, fewer fittings, fewer tubes, no cable combs, or cable management components. These are components you do not have to purchase for your build. With the pump and reservoir combo and roughly half of the loop integrated there is less assembly to be done.Ĭable management is far quicker, just clip your cables in and they are all perfectly aligned.Ī large portion of the case cost is due to the integration. Reservoir, D5 Pump Top, D5 Pump Cover, Fill Port, Drain Port, roughly half of the cooling loop.Ĭable management channels with cable combs:ģx 8pin EPS on the left side of the motherboard and up to two above the 24pin. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |